

Usually happens after a loss of power to the alarm panel. See trouble-shooting section below for more information. The built-in dialer has tried to send a message (either to the monitoring centre or your mobile phone). The alarm can no longer detect the phone line.Ĭommunication Failure. Pressing the button will display the zone, or zones that currently have a ‘trouble’ condition. Press the button to see which wireless zone (or zones) have not reported a signal to the alarm panel. One or more codepad lights will turn on to indicate which wireless sensors have a low battery. See trouble-shooting section below for more information One or more codepad lights will illuminate to indicate which of your sensors has a tamper alarm. The alarm system is drawing too much current. Here’s what they mean:ġ – Over-current fault. One or more zone lights on the codepad will light. Press 1 again to drill down to the exact fault. If it is required to cut wires to disconnect power from devices ensure to cut only one wire at a time to avoid further damaging the alarm system.Press the button on your codepad Zone Light If the sirens are still sounding you may also need to disconnect batteries and power to the individual noise making devices. Cover the exposed metal of the removed wire with electrical tape, sticky tape, blu-tac, ect.Look for the ‘AC’ markings on the main control board.If this is not easily accessible, remove one of its wires from the main control board. Switch off the plug-pack that powers the alarm at the power point.Remove the leads from either the battery or the board.Locate the leads connecting the main control board to the battery.

If the key cannot be found either drill out the lock or use brute force to access the box.If a lock, check if the key is located in the lock or on-top of/near the panel.The box cover may be fastened in place with screws or a lock. Open this device to access the backup battery and mains wiring.
Fire light flashing on networx keypad code#
This makes it noticeably larger than a typical code pad. In some systems with wireless devices the code pad is built into the alarm panel. The panel may also have the same branding as the code pad The alarm panel may be located in a cupboard, pantry, built-in wardrobe, garage wall, roof space or floor space. The alarm panel is typically a metal or plastic box measuring approx. This houses the alarm control board (the ‘main brains’) and back-up battery. It is recommended you consult the alarm installer for details regarding the specific alarm system brand and model before proceeding This information is general and may not apply to every alarm panel. WARNING – The information below is intended for the home owner or occupant in the event of their alarm going off due to a fault. If this does not stop the alarm going off you may wish to manually power-down the alarm.
Fire light flashing on networx keypad how to#
The information contained in this article will assist in shutting off the system and silence the sirens.įor information on a beeping alarm, please follow this link to ‘ How to Stop a Beeping Alarm’ This can happen for a number of reasons, including a dead battery or faulty sensor. If a fault is present you may find your alarm going off (sirens sound) by itself, even if unset.
